Raymarine A60 - Manual (Page 9)

9
Chapter 1: Introduction
This manual provides information and instructions for installing your A60 display
and RS12 GPS sensor.
1.1 Selecting the Display Unit Location
Your A60 can be mounted using the mounting bracket supplied, or console
mounted using the optional flush mount kit.
Before you install the display, plan its installation, considering:
• Convenience. The mounting location should be easily accessible to allow
operation of the front panel controls.
• Access. There must be sufficient space behind the display to allow cable con-
nections to the rear panel connectors, avoiding tight bends in the cable.
• Interference. The selected location should be far enough away from devices
that may cause interference, such as motors, generators and radio transmit-
ters/receivers (see EMC Guidelines).
• Magnetic compass. Mount the display at least 3ft (1m) away from a mag-
netic compass.
• Cable runs. The display should be mounted as close as possible to the DC
power source.
• Environmental. The display should be protected from physical damage and
excessive vibration. Although the display unit is waterproof, it is good practice
to mount it in a protected area away from prolonged and direct exposure to
rain and salt spray.
87081.book Page 9 Wednesday, December 20, 2006 2:43 PM