Roberts Gorden CGTH-30 - Manual (Page 11)

SECTION 3: I NTRODUCTION
5
Thermostat Connection - Two terminals to which
the thermostat wires will be connected.
Power Cord - Includes a three-prong plug that must
be connected to a dedicated and properly grounded
three-prong ceiling outlet.
3.5 Where Can the Heater Be Installed?
The CGTH-Series heater is intended for installation
in the following areas:
• Residential applications, such as:
- garages
- hobby greenhouses
- workshops
• Light industrial/commercial applications, such
as:
- entranceways
- lobby areas
- lunch rooms
- aircraft hangars (
See Page 7, Section 4.5.1
for restrictions)
- public garages ( See Page 7, Section 4.5.2
for restrictions)
3.6 Where Can't the Heater Be Installed?
The CGTH-Series heater is not intended for instal-
lation in the following areas:
• Residential living or sleeping areas
• Basements
Due to high temperatures, ensure that the heater
area is kept clear of furniture, draperies, clothing
or other combustible materials. Children and
adults should be alerted to the hazard of high
surface temperatures and should stay away to
avoid burns and clothing ignition. Young children
should be carefully supervised when they are in
the same room as the heater.
3.7 Installer's Responsibility
The CGTH-Series heater, the gas and electrical sup-
plies, as well as the venting, must be installed in
accordance with applicable specifications and codes.
Only firms (or individuals) well qualified in this type of
work should install the system. Consult local Building
Inspectors, Fire Marshals or your local ROBERTS
GORDON
® independent distributor for guidance.
Use the information given in this manual together
with the cited codes and regulations to perform the
installation. The heater must be installed in accor-
dance with the Minimum Required Safe Distance
from Combustibles and must bevented outside. If any
aspects of the installation are unclear, consult your
ROBERTS GORDON
® independent distributor for
clarification. The installer must furnish all needed
materials that are not furnished as standard equip-
ment. It is also the installer's responsibility to see that
the materials and installation methods used result in
a job that is workmanlike in appearance and is in
compliance with the requirements of this manual.
The installer must give this manual and the Installa-
tion, Operation and Service Manual to the owner.