Roland AR-200 - Manual (Page 39)

39
Controlling Another Device with the AR-200 (Control Output Connectors)
Applications
Controlling Another Device
(Control Out)
What is the Control Out Signal?/
Connecting Devices
The Control Out signal is output for a duration of one second
from the CONT OUT connector after playback of audio
phrases, MIDI phrases, pattern phrases, and song phrases.
This signal can be used to start amplifiers and other external
devices in sync with phrase playback.
You can set the time that is to pass after phrase playback
before output is made to anything from 0 seconds to 59
minutes 59 seconds.
Settings are made in phrase units.
The Control Out specifications are no-voltage/make-contact,
with a make-contact time of 1 second and a contact capacity
of a maximum of DC 30 V at 3 A.
Port Nos. 15 and 18 have Make-contact during output.
Note that if playback of a phrase in progress is cut off, no
Control Out signal is output.
fig.out-03
"Important Notes on Making Connections and Switching
the Power On and Off" (p. 9)
Output of Control Out Signals In Dual Mono
Mode (p. 47)
Note that Control Out signals are not output in Dual Mono
Mode (the Control Out settings are not effective).
In such instances, if the Busy Out output settings have been
made, then the Busy Out signal of the left channel is output
from the BUSY OUT connector, and right channel’s Busy
Out signal is output from the CONT OUT connector.
AR-200 Settings
* Settings for these parameters cannot be made with the AR-
200. Only phrases set on the AR-3000 are effective. For
detailed information, please refer to the AR-3000 user’s
manual.
9 1
18 15
15 18
15 18
Normal
During Output
AR-200_e.book 39 ページ ２００３年７月１４日 月曜日 午後１時１１分