RayTek ThermoView Ti30 - Manual (Page 16)

x Unit Serial Number
x Date and Time (configured by the user through the software)
x Tag name is the name of the user-defined folder from which data was uploaded
through the software. Useful tag names are department names or area associated
with the unit. This space is blank until configured by the user.
x Station is the name of the networked computer associated with a specific unit. This
is blank until configured by the user.
x Palette is the type of palette currently selected
x Firmware revisions
x Icons for LCD illumination, palette type, measurement mode and laser status
Figure 7. The Information Screen
Press the MODE button to exit the Information Screen. (Refer to Figure 9, the MODE
button is located center, below the LCD screen.) The ThermoView imager immediately goes
into measurement mode, showing a real time thermal image of what is in front of the lens. A
reticle with a crosshatch at the center of the display shows the temperature spot.
Note:
Do not change any of the settings yet. User configurable parameters will be
explained later in Figure 31.
July 1, 2003 - 16 - Version 1.0
i i
Tel: (01943) 602001- WWW.ISSLTD.CO.UK - Fax: (01943) 816796