RayTek ThermoView Ti30 - Manual (Page 18)

Settings and Controls
Keypad
Three buttons located below the LCD screen allow you to select operation modes and
change parameter values. These buttons are the MODE button, the Up button, and the
Down button. The Up and Down buttons are used mostly to increment and decrement
parameter values. They activate some special functions as well. The MODE button is used
mostly to cycle between the different operations. Details about the function of each button
are discussed later.
Down button
MODE button
Up button
Figure 9. Keypad Controls
A hinged door on the top surface of the ThermoView imager hides five switches that allow
you to change the basic imager settings. Open the hinged door by lifting it up.
July 1, 2003 - 18 - Version 1.0
i i
Tel: (01943) 602001- WWW.ISSLTD.CO.UK - Fax: (01943) 816796