RCA TM580 - Manual (Page 88)

Chapter 4
SpeedTouch™ Web Interface
E-DOC-CTC-20050429-0102 v1.0
80
4.5.9 New Content Level
Introduction This page allows you to create a new content level. To access this page:
1 On the Toolbox menu, click Web Site Filtering.
2 In the upper right corner, click Configure.
3 Under Pick a task..., click Create a new content level.
Procedure To apply a new content level following actions must be performed:
1 Content level creation
2 Content level configuration
3 Content level definition
4 Content level activation
Content level creation Proceed as follows:
1 In the Name box, type a name for the new content level.
2 In the Description box, type a short text to describe what this security level will
do.
3 Click Next.
Content level
configuration
Proceed as follows:
1 The Configuration section becomes available.
2 Click:
 Clone Existing Level
to start from a previously created content level.
 Black List
to allow all web sites by default.
 White List
to block all web sites by default.
3 Click Next.
Content level definition Only web sites that match the selected content level will be allowed. Proceed as
follows:
1 If you want to:
 Allow a category:
Select the check box next to the category name.
 Allow an entire group:
Select the check box next to the group name.
 Block a category:
Clear the check box next to the category name.
 Block an entire group:
Clear the check box next to the group name.
2 Click Apply.
! You can create up to 16 content levels.
If no levels have been defined before, this option will not be
shown.