Roland G-70 - Manual (Page 21)

Front panel
G-70 Music Workstation r
21
Switching the G-70 on/off
After connecting the G-70 to the other devices, proceed as follows:
Internal Memory Protect
After unpacking your G-70 –and before switching it on– you
need to defeat the protection of its internal memory (a solid-
state hard disk) if you intend to save data in the internal
memory.
• Use a philips screwdriver to loosen the screws, and remove
the plastic cap.
• Slide the INTERNAL MEMORY PROTECT switch to the “ ”
position to unlock the memory.
(To once again lock the internal memory, slide the switch
back to the “
” position.)
Note: Be sure to store the cap and the two screws in a safe
place in case you need them again at a later stage.
Switching on the G-70
(1) Insert the included power cable into the AC inlet and
then plug it into an electrical outlet.
(2) Press the G-70’s [POWER≈ON] button located on the
rear panel to switch it on.
(3) If you connected the G-70 to a mixing console, switch it on now.
(4) Switch on the amplifier, your active speakers, or the keyboard amplifier(s).
(5) Use the MASTER [MASTER¥VOLUME] knob to set the
G-70’s output volume.
Setting the display contrast
The information in the LCD display may be difficult to view
after turning on your G-70 or after extended use. Your
viewing angle or the current lighting conditions can also
affect the appearance of the display.
In such cases, use the [LCD≈CONTRAST] knob to the left of
the display to adjust the contrast.
Switching off the G-70
(1) Switch off all external devices.
(2) Use the G-70’s [POWER≈ON] button to switch it off.
OUTPUT
PROTECT
VIDEO
INTERNAL MEMORY
OUTPUT
PROTECT
VIDEO
INTERNAL MEMORY
MASTER
VOLUME