Roland G-70 - Manual (Page 42)

Quick Start
42
r
G-70 Music Workstation
The [USER] field lights to indicate that your settings
are now being used.
(5) Press the [EXIT] button to return to the main page.
Your last preset selection (MELODY~USER) will be
used until you select another preset or until you
switch off your G-70.
(6) Press [MINUS≈ONE] again to switch off this func-
tion.
Note: You can also switch the Minus One function on/off
using an optional footswitch (page 68).
Vocal Harmonist function
The Vocal Harmonist is another highlight of your G-70.
In fact, it doesn’t just produce harmonies: it can also
transform your voice in various ways. More impor-
tantly, its sound quality surpasses by far anything you
may already have tried.
Setting up
Here’s what you need to do to take advantage of the
Vocal Harmonist function:
(1) Connect a dynamic microphone to the INPUT jack
on the G-70’s rear panel.
(2) Set the [INPUT] switch to “MIC”.
You can also connect the (mono) output of other
instruments. In that case, you need to set the switch
to “LINE”.
(3) Set the [INPUT≈GAIN] knob on the front panel to
“MIN”.
Note: If you like, you can connect the Vocal Harmonist OUT-
PUT sockets to another amp (or additional mixer channels).
(4) Press the [SINGER] button (it must light) and switch
off the [VOCODER], [SMALL] or [ENSEMBLE] button.
(5) Sing into the microphone and gradually increase
the [INPUT≈GAIN] setting.
Set to “MIC”
Examples: Roland DR-10 or DR-20
KEYBOARD MODE ARPEGGIO
SEQ CTRL /
2
7
1
6
TRANSPOSE X-DUAL DUAL SPLIT
3
8
4
9
5
0
VARIATION TONE
ENTER PERFORM
/SYSTEM CONTROL KEYBOARD MIDI/TUNE LEVEL/PAN
/EFFECT ARPEGGIO
/ TONE PERFORM
/ PRESET USER
EDIT UTILITY
DRUM ENVELOPE FILTER VIBRATO TONE
CANCEL EXIT
UPPER LOWER
ROM PLAY
VOLUME PALETTE
SELECT ON/OFF
PART
VALUE EDIT
1 2 COMBINATION PALETTE
Preset:001 1>Piano 1
L/MONO
Synthesizer, sound module, etc.
Set to “LINE”
INPUT GAIN
OVER
MIN MAX
SINGER