RCA CC543 - Manual (Page 63)

To connect your camcorder to a TV without audio and video input jacks, you will need
I an optional RF output adapter and an optional coaxial RF cable.
!
O p t i o n a l o h m
Transformer
. ,
I ( s u c h a s 1 9 3 9 8 3 )
t
Optional
O p t i o n a l C o a x i a l R F C a b l e
(such as
or T O T V
0
1 Disconnect the VHF antenna from
your TV. If you are going to leave
the RF adapter connected to the TV,
connect the antenna to the RF output
adapter.
antenna is round 75-ohm cable,
connect it to IN FROM ANT
connector on RF output adapter.
B. If antenna is flat twin-lead,
connect flat-lead connectors to
screw terminals on optional 300-
75 ohm transformer. Then
connect transformer to IN
ANT connector on RF output
adapter.
54
0
2 Attach one end of coaxial RF cable
to OUT TO TV connector on RF
adapter, and attach other end of the
cable to VHF input on TV as shown.
Note: If TV has screw terminals, you
may need an optional 75-to-300 ohm
transformer, such as AH01 1.
0
3 Attach RF output adapter’s yellow
plug to the jack, small plug
to the RF DC OUT jack, and white
plug to the AUDIO jack on the side
of the camcorder.
0
4 Place the AV switch to
OUT.