Runco CR-26HD - Manual (Page 19)

Controls and Functions
Runco CR-26HD/CR-32HDi Owner’s Operating Manual 9
PRE
L
IMINAR
Y
1. OFF / ON
Use these buttons to turn the Crystal Series LCD Display on or off.
2. Numeric Buttons
Use these buttons to enter TV channel numbers or menu pass codes. Use the 100
button to enter channel numbers above 99. Use the
-
button to enter DTV
sub-channel numbers.
3. TIMER OFF Button
Press this button to set the sleep timer. Press it repeatedly to scroll through the
available options (Off, 10, 30, 60, 120 or 180 minutes).
4. Source Selection Buttons:
INPUT 1
Press this button to switch to Input 1.
INPUT 2
Press this button to switch to Input 2.
INPUT 3
Press this button to switch to Input 3.
DVI
Press this button to switch to the Digital Video input.
RGB HD
Press this button to switch to the RGB HD input.
TV
Press this button to switch to the Antenna/DTV/CATV input.
5. Memory Preset Buttons:
CUST
Press to recall settings for the current input from the “Custom” memory preset.
ISF NT (Night)
Press to recall settings for the current input from the “ISF Night” memory preset.
ISF DAY
Press to recall settings for the current input from the “ISF Day” memory preset.
Input 1 and Input 2 have both S-Video and composite video
connectors. Input 3 has both component and composite video
connectors.
To specify which connection type you are using – or to switch from
one to the other if equipment is connected to both – use the Input
Selection menu under Setup (refer to Input Selection on page 37).
Note