Runco CR-26HD - Manual (Page 59)

Runco CR-26HD/CR-32HDi Owner’s Operating Manual 49
PRE
L
IMINAR
Y
6.1
RS-232 Connection
and Port Configuration To interface the Crystal Series LCD Display with a home theater automation/control
system or a PC running terminal emulation software, connect it to your control system or
PC as shown in Figure 3-8.
Configure the RS-232 controller or PC serial port as follows: no parity, 8 data bits, 1 stop
bit and no flow control. Set the baud rate to match that of the Crystal Series LCD Display
RS-232 port; the default baud rate is 115200.
6.2
Serial Command
Syntax Table 6-1 lists the RS-232 command set. All commands are in ASCII format. A carriage
return is not required after a command.
When you send a valid command, the Crystal Series LCD Display executes it and
acknowledges it with a right-bracket character (]) followed by the four-digit numeric code
you sent; for example, ]0002. When you send an invalid command, the Crystal Series
LCD Display ignores it and returns -N/A instead of the four-digit code.
6. Serial Communications
Table 6-1. Serial Commands
Command Description
[ S3A 0### Set audio volume to ### (=000-100)
Example: [S3A0075 sets volume to 75
[ +3A Audio volume up
[ -3A Audio volume down
[ S4A 000# Main input selection
0=TV
1=Input1
2=Input2
3=Input3
5=DVI
6=RGB
Example: [S4A0006 selects RGB
[ S4E 000# Aspect ratio selection
0=Standard (4x3)
1=VirtualWide
2=Letterbox
3=Anamorphic
Example: [S4E0002 selects Letterbox
[ S4F 0101 Select Composite Video for Input1
0102 Select S-Video for Input1
0201 Select Composite Video for Input2
0202 Select S-Video for Input2