Runco CR-26HD - Manual (Page 26)

Installation
16 Runco CR-26HD/CR-32HDi Owner’s Operating Manual
PRE
L
IMINAR
Y
3.4
Connections to the
Crystal Series LCD
Display Proceed as follows to connect the Crystal Series LCD Display to your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
• Use the left audio input when connecting mono audio sources.
Rear Connector Access To access the left rear connector panel, push down on the plastic clip holding the cover in
place. Then, pull firmly on the cable access cover to open it.
Connecting the Crystal
Series LCD Display to
Source Components
Connect your video sources to the Crystal Series LCD Display as shown and described in
the sections that follow.
Antenna/Cable TV Connection: Connect your antenna or cable television source to the
ANT jack on the rear of the Crystal Series LCD Display; see Figure 3-1.
Figure 3-1. Antenna/Cable TV Connection
DVI Connections: The Crystal Series LCD Display has a DVI input for connecting a DVD
player, DTV decoder, personal computer or any other device with a DVI or HDMI output.
Connect such devices as shown in Figure 3-2.
➤
➤
Use the DVI inputs whenever possible. This ensures the highest
video quality because the signal is carried in the digital domain
throughout the entire signal path, from source component output
into the display.
INPUT3
or
Cable Television
Network
Input Panel
Tip