Roadmaster Multi-Media Headunit VRVD630 - Manual (Page 14)

5
Radio Operation
VOLUME 25 AM 07:12
FM1 STEREO LOC
RADIO
107.15 MHZ 2
Radio Screen
Selecting the Frequency Band
Press BAND button repeatedly to
select the desired radio band.
Stereo/Mono
FM listening is generally done in Ste-
reo mode. If the signal is weak or re-
ception is not as good as you would
like, switching to Mono mode usually
improves the overall sound quality. To
switch to Mono mode, press ST (or
MO/ST on the remote control). Press it
again to return to Stereo mode.
Local/Distant
In urban settings, most stations are
strong enough to listening in LOCAL
mode.
However, if a station seems too distant
to be received well, try switching to
DISTANT mode by pressing and hold-
ing ST/LOC (or pressing LOC on the
remote control).
Press it again to return to LOCAL
mode.
Selecting Stations
. Press a preset station button -6 to
select a station which has been stored
in the memory.
2. Press and hold the
or buttons
until “MANU” appears on the screen,
then press the
or buttons to se-
lect a station.
If the buttons have not been pressed
for several seconds, the unit will return
to automatic seek mode.
Automatic Memory Storage &
Program Scanning
• Automatic Memory Storing
This feature is used to automatically
set up presets for the radio.
. Press and hold the AS/PS to start
the tuner searching the frequency band
(FM, FM2, FM & AM, AM2) and stor-
ing the six strongest stations as pre-
sets.
• Program Scanning
After the presets have been recorded,
. Press the AS/PS button and the
radio will scan the preset buttons in
order. It will play a station for a few
seconds, and then move to the next
station.
2. When you hear a station that you
wish to listen to, press the AS/PS but-
ton again to stop the scanning.
• Setting up Presets Manually
To set up the presets manually, tune to
the desired station using the
and
buttons.
When you find a station you would like
to save to memory, press and hold the
desired preset button for a few sec-
onds to store it.
RDS Operation
(Radio Broadcast Data System)
Setting RDS mode
Press AF/REG button to turn the RDS
mode ON/OFF.
Whenever RDS is on, symbol “AF” ap-
pears on the display.
Program name is displayed when re-
ceiving an RDS station.
“AF” starts blinking if the broadcasting
signals getting worse. “ALARM” will be
displayed when an emergency broad-
casting is received, meanwhile sound
output level will be automatically ad-
justed to the preset output level when
the volume level is set at minimum.