Roberts Radio WM201 - Manual (Page 59)

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Specifications
Power Requirements
Mains AC 230 volts, 50Hz only
Battery (Remote control) CR2032
Connectivity
Wired Ethernet
10/100M bits/sec via RJ-45
Wi-Fi 802.11b and 802.11g supported
WEP and WPA encryption supported
Circuit features
Loudspeaker 2 x 75 mm
Output Power 5 Watts RMS per channel
Headphone socket 3.5mm dia
Auxiliary In socket 3.5mm dia
Line Out socket 3.5mm dia
Aerial System External Wi-Fi Antenna
General
Do not allow your radio to be exposed to water, steam or sand. Do not
leave your radio where excessive heat could cause damage.
The name plate is located on the rear of the radio.
The Company reserves the right to amend the specification without notice.
• The radio shall not be exposed to dripping or splashing and no objects
filled with liquids, such as vases, shall be placed on the radio.
• It is recommended to operate the product such that there is a minimum
distance (10cm recommended) to adjacent objects in order to ensure
good ventilation.
• The ventilation of the product should not be restricted by covering it
with items such as newspapers, tablecloths, curtains etc.
• No naked flame sources such as lighted candles should be placed on
the product.
• It is recommended to avoid using or storing the product at extremes
of temperature. Avoid leaving the unit in cars, on window sills, in direct
sunlight etc.
58