Raymarine Radome Scanners - Manual (Page 20)

16 Radome Scanners - Users Guide
Completing the installation
CAUTION: Toggle and cord
Make sure the toggle and cord is correctly stowed before
replacing the radome cover. Failure to do so will result in the
antenna being unable to operate.
1. Holding the cover securely, remove the cord and toggle from the
retaining hole.
2. Coil and place the cord in the storage compartment.
Secure in place by fixing the toggle on top of the cord
(see inset).
3. Place cover onto the base unit ensuring the markers
are aligned - see right.
4. Tighten the captive screws just sufficiently to secure.
DO NOT OVERTIGHTEN.
5. Ensure nut is tightened sufficiently to enable gland to
make a watertight seal around the cable
D8863_1
D8984_1