Regency FireGenie - Manual (Page 19)

FPI FireGenie TM Remote Control Manual 19
Displaying Temperature in Celsius or Fahrenheit
The default setting of the Remote Control is to display the temperature in Fahrenheit.
However, the Remote Control can be changed to display temperature in Celsius by the following
steps:
1. Ensure the Remote Control is switched off by using the On/Off button.
2. Press and hold the “-” button.
3. While the “-” button is held down, press and release the “+” button, this will toggle the
temperature display between °C and °F.
This setting is stored in memory hence the Remote Control will continue to display the
temperature in Celsius even if the battery is replaced.
Time Period 1
On-Time Off-Time
8:00 am 2:00 pm
1:00 pm 4:00 pm
On-Time Off-Time
Time Period 2
Operates in Time Period 1 Setting Operates in Time Period 2 Setting
Special Conditions in Program Mode
o If the On-Time of a Time Period matches the Off-Time of the same Time Period, the Time
Period is disabled.
o If the Off-Time of the First Time Period crosses over to the On-Time of the second Time
Period, the Off-Time of the fi rst Time Period will have precedent, for example, if Time Period
1 is programmed to end at 2:00 pm whereas Time Period 2 is programmed to commence at
1:00 pm, the following will occur: