Rabbit Air MinusA2 SPA-780A - Manual (Page 10)

1. Open the particle sensor cover on
the right side of the unit (when
facing the unit).
2. Use a damp cotton swab to clean
and dry the lens, dust inlet and dust
outlet.
1. Remove the front panel from the unit and use
a dry cloth, soft brush, or cotton swab to dust
off the mood light lens on the back of the panel.
Cleaning and Maintenance
Always unplug the unit before cleaning.
Cleaning the Particle Sensor
outlet air inlet
Cleaning the Air Intake and Outlet
Cleaning the Front Panel
Cleaning the Mood Light Lens
Cleaning the Unit Surface
Cleaning the Pre-filter
1. Remove the front panel from the unit and use a dry
cloth or soft brush to dust it off.
1. Clean the air intake and outlet with a soft brush.
• To clean the Pre-Filter - vacuum method:
1. Remove front panel from the air purifier
2. Run a vacuum cleaner with a nozzle or brush attachment on low power setting
along the Pre-Filter to remove visible particles.
If vacuuming does not seem to sufficiently clean your Pre-Filter, please follow the steps
below to wash it.
• To clean the Pre-Filter - washing method:
1. Remove the Pre-Filter from the unit.
2. Fill the sink with lukewarm water and gently wash the Pre-Filter under the water
for 2-3 minutes or until it is completely clean.
3. Rinse the Pre-Filter with clean tap water.
4. Use a towel to remove any excess water from the Pre-Filter.
5. Allow the Pre-Filter to dry for 12-24 hours.
6. When the Pre-Filter is completely dry, place back into the air purifier.
1. Use a clean, dry cloth to wipe the external surfaces of the air purifier.
Clean particle sensor every three to six months.
Clean the air intake and outlet using a vacuum cleaner
or soft brush.
Caution: Be careful not to drop the brush into the unit.
Use a damp cloth to remove stubborn stains
and dirty buildup if necessary. Avoid
commercial cleaning products.
Use a damp cloth to remove stubborn stains
and dirty buildup if necessary. Avoid
commercial cleaning products.
The unit surface should be cleaned depending on the air
quality of the room.
Use a damp cloth to remove stubborn stains and dirty buildup if necessary. Avoid
commercial cleaning products which may damage the unit's surface.
The Pre-Filter should be cleaned depending on the air quality of the room.
dust outlet
dust inlet
17 18