Rabbit Air MinusA2 SPA-780A - Manual (Page 12)

Do not attempt to install this product if you do not understand the instructions.
Contact a qualified contractor to install the mounting bracket and call 1-888-866-
8862 if you have any questions. You risk the possibility of damaging the Air Purifier,
damaging other property and personal injury if the mounting bracket is not
installed properly. Check to make sure there are no missing or defective parts. Do
not attempt to install the mounting bracket if there are missing or defective parts.
Contact Rabbit Air and replacement parts will be shipped to you immediately.
Rabbit Air is not liable for damage or injury caused by incorrect mounting, incorrect
assembly or incorrect usage.
• After installing the wall-mount bracket, make sure it is firmly in place before
putting the MinusA2 Air Purifier on it.
• Take care not to drill or screw into existing wiring in the wall while installing the
wall-mount bracket.
Correct installation is extremely essential, and falls outside the scope of responsibil-
ity of Rabbit Air. Please consult a qualified contractor and/or specialist supplier to
install the mounting bracket. Maximum weight of air purifier SPA-780A / SPA-700A:
9.1 kg/20lbs.
Wall-Mounting your MinusA2
Disclaimer for installing wall-mounted objects
The Energy Star Label and disclaimer:
The energy efficiency of this ENERGY STAR qualified model is measured based on a
ratio between the model’s CADR for Dust and the electrical energy it consumes, or
CADR/Watt.
Only use the approved Rabbit Air wall-mount kit to install the MinusA2 Air
Purifier on your wall. The MinusA2 Air Purifier is designed to be either free
standing or wall-mounted.
Don’t have a wall-mount kit? Want one? Order online at www.rabbitair.com
or over the phone at 1.888.866.8862
21 22
(Optional)
Wall-mount installation guidelines:
• Make sure the MinusA2 Air Purifier has at least two feet of clearance from the ceiling
and eight inches of clearance on either side.
• Be careful not to drop the front panel or filter case when replacing the filters.
• Do not pull on the power cord.
• Make sure the hanger screws have been securely driven into studs.