Roadmaster VR3 VR500CS-BT - Manual (Page 20)

1. RCA Output
The RCA Output Jacks are on the back of
the unit. (Refer to Wiring Diagram) This out-
put is for connecting an amplifier, equalizer,
or other audio componement that requires
a pre-amp out connection. (Red = Right,
White = Left) Follow the manufacturers in-
structions for the audio component that you
are connecting.
2. Sub Woofer Output
The Sub Woofer Output Jack is on the back
of the unit. (Refer to Wiring Diagram) This
output is for connecting an amplifier, that
requires a pre-amp out connection. (Red =
Right, White = Left)
To use the Subwoofer Out Jack press
SUB/# Button on the front panel, or press
the #/SUB Button on the remote control to
turn the Sub Woofer Jack ON or OFF.
The unit must have an external amplifier in-
stalled to drive the subwoofer.
Follow the manufacturers instructions for
the audio component that you are connect-
ing.
ID3 TAG & SCROLLING MODES
If an MP3 or WMA file has ID3 Tag informa-
tion, it will be displayed on the LCD in one
of 2 scroll modes, SCROLL 1 or SCROLL 2.
ID3 information varies from file to file
If there is no ID3 Tag information, nothing
will shown on LCD. Press the BND/ID3 but-
ton anytime to view the ID3 information of
the song.
SCROLL 1 displays the ID3 information 8
characters at a time.
SCROLL 2 displays the ID3 information by dis-
playing the first 8 characters, then scrolls the
information across the LCD from left to right.
To choose a scroll mode, press and hold
the Volume knob and DSP Off will be dis-
played.
Press the volume knob 5 more times and
SCROLL 1 will be displayed.
Rotate the Volume knob to change between
the 2 modes. Leave the unit idle for a few
seconds and the ID3 information will auto-
matically start scrolling.
Both Scroll modes display the same infor-
mation in the same order.
MAINTENANCE
Cleaning the Unit
Do not use any liquids to clean this unit.
Do not use petroleum distillates to clean
this unit.
Use a clean, dry cloth to clean this unit.
Replacing the Fuse
Make sure the amperage matches the spec-
ified value when replacing the fuse(s). If the
fuse is bad, check the power connection
and replace the fuse with a new one. If the
same problem occurs, this might indicate a
malfunction within the unit.
WARNING
When replacing a fuse, do not use a fuse
with a higher amperage rating than the fuse
originally supplied with your unit, otherwise
damage will result to your unit.
• Antenna Socket
• Sub Woofer Out
Red = Right
White = Left
Red = Right
White = Left
• RCA Pre-Amp Line Out
19
RCA Out, SUB Out & ID3 Tag