Rinnai IB35ETRLC User Manual
Page 12
12
NOTE: Some fluorescent lights may
interfere with the transmission of remote
control signals, in this case changing the
position from which you are operating the
remote control may help.
Avoid getting the remote control wet, or
dropping it.
The remote control works within 15 feet and
an angle of 40° to the receiver on the unit.
• TO REPLACE REMOTE CONTROL
BATTERY
The battery is held in a clip that slides out
the bottom of the remote control. The clip
is removed by inserting a coin or similar
into the recess in the back of the remote
control and sliding downwards.
The battery must be of type CR 2032 and
will only operate if installed the right way
up, as shown below.
Remove the battery if the remote control is
not going to be used for a long period. This
will help avoid damage from leaking
batteries.
ON BUTTON
Operates the unit
manually.
OFF BUTTON
Stops unit
manually.
TEMPERATURE
ADJUSTMENT
Increases or
decreases
the temperature
setting.
REMOTE CONTROL
BACK
BATTERY
Note the + side of the battery is
facing the rear of the remote
control