Rinnai IB35ETRLC - Manual (Page 8)

8
A This appliance is equipped with an
ignition device which automatically
ignites the pilot. Do not try to light the
pilot by hand
B. BEFORE OPERATING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle on
the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance
• Do not touch any electrical switch
• Do not use any phone in your building
• Immediately call your gas supplier from
STOP Read the safety information
above.
• To turn the unit on (Refer to diagram
below)
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
FOR YOUR SAFETY READ BEFORE OPERATING
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
Turn off the appliance by operating the On/
Off button and turn off the power at the wall
switch. Disconnect the electric plug. This will
isolate the gas supply and prevent the
solenoid valve from opening.
a neighbour’s phone. Follow the gas
suppliers instructions.
• If you cannot reach your gas supplier call
the fire dept.
C. Use only your hand to push the gas
control buttons. Never use tools. If the
buttons will not activate by hand, don’t
try and repair it, call a qualified service
technician. Force or attempted repair
may result in a fire or an explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect
the appliance and to replace any part
of the control system and any gas control
which has been under water.
If the appliance does not light it will
automatically turn off.
To re-attempt ignition, press the On / Off
button again.
• To adjust the heat
Press the “ “ and “ “ buttons to
increase and decrease the room
temperature setting.
• To turn the unit off
Press the On /Off button. The appliance will
turn off.
If the appliance will not operate; follow the
instructions “to turn off the gas to appliance”
and call your service technician or gas
supplier.
Do not attempt to light the pilot by hand.
Wait for five minutes to clear out any gas.
Then smell for gas, including near the
floor. If you smell gas, STOP! Follow
“B” in the safety information above. If you
don’t smell gas, go to the next step.
Press the On / Off button. This operates
the ignition sequence.