RCA HD Receiver - Manual (Page 20)

Setup and Connections
18
Step 7: Connect the VCR Controller
For the HD receiver to control your VCR, you need to attach the VCR Controller to the
back of the HD receiver and the front of the VCR.
1. Plug the VCR Controller into the VCR CONTROL jack on the back of the HD receiver.
2. Affix the other end to the remote sensor on your VCR. (See “How to Locate the VCR’s
Remote Control Sensor” for details.)
VCR Controller
ANTENNA B IN ANTENNA A IN OUT TO TV
VIDEO S-VIDEO HD MONITOR OUT AUDIO VCR CONTROL DIGITAL AUDIO OUTPUT
PHONE JACK SATELLITE IN
ACCESS CARD
R
R
L
L
REMOTE SENSOR
VCR
Front of VCR
Back of HD Receiver
How to Locate the VCR’s Remote Control Sensor
The VCR Controller must be affixed directly over the infrared remote sensor on your VCR.
Some VCRs have a label that identifies the infrared remote sensor, and others do not. If
the IR sensor is labeled on your VCR, affix the VCR Controller directly over the sensor.
For VCRs that do not have a label for the remote sensor, you need to use the VCR’s
remote to locate the sensor before affixing the VCR Controller.
1. Hold the VCR’s remote control so that it is touching the front of the VCR.
2. Slowly move the remote over the front of the VCR while pressing the remote power
button on and off.