RCA VR646HF - Manual (Page 53)

51
Connections
Things to Know Before
Connecting Components
Protect Your Components from Power Surges
• Connect all components before plugging any power
cords into the wall outlet.
• Always turn off the TV and other components
before you connect or disconnect any cables.
Position Cables Correctly to Avoid Audio Hum or
Interference
• Insert all cable plugs firmly into their jacks.
• Place the audio/video cables to the sides of the TV’s
back panel instead of straight down the middle after
you connect your components.
• Try not to coil any twin-lead cables and keep them
away from the audio/video cables as much as
possible.
• Make sure all antennas and cables are properly
grounded. Refer to the Safety Tips sheet packed with
your unit.
Protect Your Components from Overheating
• Do not block ventilation holes in any of the
components. Arrange the components so that air
can circulate freely.
• Do not stack components.
• Allow adequate ventilation when placing your
components in a stand.
• Place an amplifier or satellite receiver on the top
shelf of the stand so heated air rising from it will not
flow around other components.
Things to Know
Before connecting
Components
5
➣
➣
SETTING UP THE VCR
2
FIRST THINGS FIRST
1
➣
RECORDING
3
VCR BASICS
4
➣
OTHER FEATURES
7
6
Connections
➣
5
➣
5
➣
8
REFERENCE
PROGRAM THE REMOTE