RCA VR646HF - Manual (Page 6)

First Things First
4
Step 1: What’s in the Box?
The following items come packed in the box:
• VCR
• Remote control
• RF coaxial cable
STEP 2: Install Batteries In the
Remote Control
Follow these steps whenever you need to install or change the
batteries in your VCR remote.
1. Remove the cover of the battery compartment.
2. Place the batteries into the remote’s back panel. Match the
positive (+) and negative (–) ends of each battery to the
diagram inside the battery compartment.
3. Replace the cover.
STEP 3: Connect your VCR
If you connect your VCR to your home antenna or cable system
and then to your TV, use the VCR’s ANT. IN and RF OUT jacks for
a good signal as shown to the right.
If you have a TV with AUDIO/VIDEO jacks, use the jacks for a
better connection. Refer to the section, Connections, toward
the back of the manual, for additional connection options.
STEP 4: PLUG IN THE VCR
Your VCR’s power cord has a plastic band strung through the
blades. Remove plastic band before plugging the cord into
the power outlet. To remove band, cut with a pair of scissors
and pull it free of the blades. Once the plastic is removed, match
the wide blade of the power cord to the wide slot in the AC
outlet. Be sure to insert the plug completely.
STEP 5: Tune THE TV
Tune the TV to the VCR viewing channel. The VCR viewing
channel is channel 3 or 4 or the TV’s video input.
VCR
TV
CABLE/
ANTENNA
CABLE, CABLE BOX, OR ANTENNA
ANT. IN
RF OUT
3 CH. 4
VIDEO
AUDIO
OUT IN
L
R
REV
RECORD
INPUT AUDIO VIDEO
TRACKING
RIGHT
STOP¥EJECT TAPE SPEED
PLAY
P A USE FWD
TV¥VCR POWER CHANNEL LEFT MONO
INP UT TV •VCR
REVERSE PLAY FORWARD
RECORD STOP PAUSE
INFO SEARCH
MUTE GO BACK
1 2 3
4 5 6
7 8 9
0
F.ADV
TV VCR
TRACKIN
ON OFF
CHAN
V O L V O L
CHAN
CLEAR MENU SPEED