RocketFish ROCKETBOOST RF-RBWS01 - Manual (Page 22)

22
Joining the wireless sender/receiver and wireless speaker
to an existing Rocketboost network
Use this procedure only if you are adding this product to an existing
Rocketboost network.
You need to join both the wireless sender/receiver and the wireless
speaker to your existing hub device, using the following steps.
To join an existing Rocketboost network:
1 Set the HUB switch on the wireless sender/receiver to DISABLE.
• The power indicators turn green when the HUB switch is set to ENABLE.
• The power indicators turn blue when the HUB switch is set to DISABLE.
2 Press and hold the POWER button on the your Rocketboost Hub device for
more than three seconds to put it into joining mode. The power
indicator starts blinking rapidly and the unit will stay in joining mode for
30 seconds.
3 Press and hold the button on the wireless sender/receiver for more
than three seconds so the Hub device and wireless sender/receiver enter
joining mode.
• The power indicators light steadily if the joining was successful.
• The power indicators blink slowly if the joining was not successful.
Wireless speakers
RF-RBUSB or other
Rocketboost device.
(HUB: ENABLE)
Wireless sender/receiver
(included with speaker)
(HUB: DISABLE)
RF-RBWSO1_11-0202_MAN_V1.fm Page 22 Monday, May 2, 2011 11:46 AM