RocketFish ROCKETBOOST RF-RBWS01 - Manual (Page 23)

23 RF-RBWS01
4 Press and hold the POWER button on the your Rocketboost Hub device for
more than three seconds to put it into joining mode. The power
indicator starts blinking rapidly and the unit will stay in joining mode for
30 seconds.
5 Press and hold the button on the wireless speaker for more than three
seconds so the Hub device and wireless speaker enter joining mode.
• The power indicators light steadily if the joining was successful.
• The power indicators blink slowly if the joining was not successful.
Note : Rocketboost devices have their own memory. After the devices are joined once,
they will remember each other and join automatically when your devices are
powered on again. Because of this, you can join all of your network components in
the same room before installing them in their permanent locations throughout the
house.
Listening to music
To listen to music:
1 Turn on the wireless sender/receiver and wireless speaker. The power
indicator LEDs should light steadily. If they are blinking you need to
rejoin the wireless sender/receiver and wireless speaker. See
“Establishing communication” on page 19.
2 Select either USB-In or LINE-In using the remote control, depending on
which audio input you are using.
3 Play music from the audio device or your computer connected to your
wireless sender/receiver and listen to it from the wireless speaker.
4 Adjust the volume level on your wireless speaker. If you have multiple
audio sources in your Rocketboost network, press the Source button on
the wireless speaker to hear the next audio source. Press the Source
button again to cycle through all available audio sources.
RF-RBWSO1_11-0202_MAN_V1.fm Page 23 Monday, May 2, 2011 11:46 AM