Hp4600 controls, 2006 directed electronics, all rights reserved – Orion HP-4600 User Manual
Page 5
HP-2300, HP-2400, HP-2600 Connections
1.
ATC Fuse - ATC fuses protect the amplifier against internal electrical damage and
is meant to protect the amplifier only. All other power connections should be
fused at the source. The HP-2300 has (1) 20-amp, the HP-2400 has (1) 30-amp, the
HP-2600 has (2) 20-amp fuses.
2.
+BAT - connect this terminal through a FUSE or CIRCUIT BREAKER to the positive
terminal of the vehicle battery or the positive terminal of an isolated audio sys-
tem battery.
WARNING:
Always protect this power wire by installing a fuse or circuit breaker of the
appropriate size within 12 inches of the battery terminal connection.
3.
REM - this terminal turns on the amplifier when (+) 12 volt is applied. Connect it
to the remote turn on lead of the head unit or signal source. If a (+) 12 volt remote
turn lead is not available, a Remote Power Adapter (P/N #55000) can be used to
supply a remote turn on signal. DO NOT connect this terminal to constant (+) 12
volt.
4.
GND - power return connection. Connect this terminal directly to the sheet metal
chassis of the vehicle, using the shortest wire necessary to make this connection.
Always use wire of the same gauge or larger than the (+) 12 volt power wire. The
chassis connection point should be scraped free of paint and dirt. Use only quali-
ty crimped and/or soldered connectors at both ends of this wire. DO NOT connect
this terminal directly to the vehicle battery ground terminal or any other factory
ground points.
5.
Speaker - connect the speakers to these terminals. (refer to the Speaker
Connection section of this guide.)
NOTE:
Make all connections to power, ground, speakers, and remote terminals before
final positioning and installation of the amplifier in the vehicle.
HP4600 Controls
1.
Hi Input (high level input Ch 1/2 and Ch 3/4) - Accepts 1v to 10v input from the head
unit’s speaker output. The amplifier will automatically wake-up when the input is
greater than 1V (on channel 1/2 high level input only).
GAIN
MIN MAX
INTELLIBASS
0dB 12dB
INTELLIBASS
0dB 12dB
GAIN
MIN MAX
2 CH
1 CH
INPUT
4 CH
3 CH
R CH
L CH
LINE OUT
REMOTE
LPF FLAT HPF
X-OVER
HPF
50Hz 500Hz
LPF
50Hz 500Hz
LPF FLAT HPF
X-OVER
HPF
50Hz 500Hz
LPF
50Hz 500Hz
POWER
(GREEN)
PROTECT
(YELLOW)
1
2
3
4
5
6
7
8
9
10
11
HI INPUT
1/2 CH
HI INPUT
3/4 CH
INPUT
MODE
1/2 CH
3/4 CH
SPEAKER
+BAT
REM
GND
FUSE
1
2
3
4
5
+
L CH
+
R CH
-
L CH
-
R CH
BRIDGE
4
© 2006 Directed Electronics, all rights reserved