Oki MICROLINE 320 TURBO - Manual (Page 32)

32 Microline 320/321 Turbo
|
4 Make sure the wire feed guide (1) is secured in the sheet
guide.
32T-33.eps
QUIET PARK TEAR FF/LOAD LF
SEL SEL
POWER ALARM
MENU
GROUP
EXIT
ITEM SET PRINT
MENU SHIFT
TOF
Micro Feed Up
Micro Feed Down PRINT QUALITY
CHARACTER PITCH
HSD NLQ UTL SSD
10 12 15 17 20 PROP
5 Adjust the paper feed guides (1) for the width of the paper.
Place a sheet of paper in the separator. The paper will feed
into the printer.
32T-15.eps
QUIET PARK TEAR FF/LOAD LF
SEL SEL
POWER ALARM
MENU
GROUP
EXIT
ITEM SET PRINT
MENU SHIFT
TOF
Micro Feed Up
Micro Feed Down PRINT QUALITY
CHARACTER PITCH
HSD NLQ UTL SSD
10 12 15 17 20 PROP
! Important!
If the paper does not feed in, remove it. Check the paper
lever position. Make sure the ALARM light is on: if it is
flashing, hold the SHIFT key and press the
CHARACTER PITCH (RESET) key. Reload the sheet
of paper.
! The factory default setting for the Top of Form (where
the printing should begin) is one inch down from the top
of the page. To change the setting, see “Using Your
Printer, Top of Form (TOF).”
1
1