Sylvania SRPD442 - Manual (Page 12)

12
OPERATING THE PLASMA DISPLAY
POWER
INPUT SELECT
DISPLAY
VOL
MUTE
SCREEN MODE
STILL
SCREEN MODE
CHANGING THE ASPECT RATIO (SCREEN MODE)
By changing the aspect ratio of the screen you
can select the manner in which you wish to view
the picture.
1 Press the SCREEN MODE button to display
the current screen mode.
2
Press the SCREEN MODE button a second
time to change the screen mode.
Mode
Normal
Explanation
Normal will display a 4:3 picture at its standard 4:3 size.
For 1080i and 720p video signals, a picture will be displayed
at 16:9 size.
Picture
Normal
Wide
Full
Zoom
Wide
Wide will display a 4:3 picture at a 16:9 size, with less
horizontal elongation necessary to fill the screen because a
little bit of the top and bottom will be cut off.
Full
Full will display a 4:3 picture at a 16:9 size, with horizontal
elongation necessary to fill the screen.
Zoom
Zoom will magnify the entire 4:3 picture to fill the screen, with
no horizontal elongation to fill the screen, as more of the top
and bottom are cut off. Use this mode to view letterboxed 4:3
picture content to get a widescreen picture. A 16:9 picture will
be magnified similarly, but to a lesser extent.
Each time you change the screen mode, the
name of the selected mode is displayed on the
screen for approximately 4 seconds.
The SCREEN MODE button switches between
the screen modes in the following pattern.
NOTE:
• When switching the input signal, the audio mute
turns ON temporarily.
• You can only select the "Normal" and "Zoom"
screen modes for 1080i and 720p video signals
connected to the COMPONENT 2 terminal.
Zoom Normal Full Wide