Olicom A400A User Manual
Page 12
10
Options are : Serial port, Network
Serial port :You can use the attached console cable to connect the
router and a personal computer to configure, administer and monitor
your ADSL router with Graphic User Interface (GUI).
a) Plug the RJ-14 end of console cable into the CONSOLE port
on the router back panel.
b) Connect the other DB-9 end of console cable to a serial port
(COM1 or COM2) of your computer.
Network: Or you can open a Network connection from a
workstation on your network. You must know the IP address of
the router before you can make a Network connection to it. By
default , the router uses 192.168.1.1 as the IP address for its
LAN interface. You can use the Graphic User Interface (GUI)
to configure the router IP address.
Retry interval: Enter the timing of how many seconds you want
to reconnect the router if failure. (The default is 3 seconds.)