Olicom A400A - Manual (Page 23)

21
IPoA (RFC 1483 route)
The Routed protocol data unit is encapsulated using RFC 1483 protocol
over an ATM network and this operation mode connect and communicate
directly with Internet through ATM/ADSL.
1. VPI: Enter the number of the virtual path identifier in the VPI
field.
The VPI is a number in the range 0-255. Consult your ATM transport
administrator for what number you should enter in this field.
2. VCI: Enter the number of the virtual circuit identifier in the VCI
field.
The VCI is a number in the range 0-65534. Consult your ATM
transport administrator for what number you should enter in this field.
3. Encapsulate: Select the encapsulation setting.
You choose LLC or VC Mux to configure whether the virtual circuit
uses LLC-SNAP encapsulation or Vc-based multiplexing.
4. IP: Enter the IP address the ADSL router will use on this
virtual circuit in the IP Address field.
The IP address you enter must not be in use by other devices on
this virtual circuit. The domain of Ip have to not same as LAN.
5. Netmask: Enter the subnet mask for the network connected to
this virtual circuit in the Netmask field.
The subnet mask specifies which bits of the 32-bit binary IP address
represent network information. Most sites should use 255.255.255.0
for their subnet mask.