Onkyo Network A/V Receiver HT-R690 - Manual (Page 11)

11
En
Connections
Connecting the AV Receiver
Connecting the Speaker Cables
The following illustration shows which speaker should be connected to each pair of terminals. If you’re using only one
surround back speaker, connect it to the SURROUND BACK or FRONT HIGH L terminals.
Tip
• You can specify whether surround back or front high speakers are connected in the “Speaker Configuration” menu (
➔ page 42) or
during Audyssey 2EQ ® Room Correction and Speaker Setup (
➔ page 28).
• The speakers you can connect will differ depending on the speaker system that you have.
■
Screw-type speaker terminals
Strip 1/2" to 5/8" (12 to 15 mm) of insulation from
the ends of the speaker cables, and twist the bare
wires tightly, as shown. (Supplied speaker cables are
already stripped.)
■
Push-type speaker terminals
Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of the
speaker cables, and twist the bare wires tightly, as shown. (Supplied
speaker cables are already stripped.)
Connecting Your Speakers
Surround back/
Front high
right
Surround
left
Surround
right
Center
Front left Front right Surround back/
Front high
left
1/2" to 5/8" (12 to 15 mm)
3/8" to 1/2" (10 to 12 mm)