Onkyo Network A/V Receiver HT-R690 - Manual (Page 37)

37
En
You can display various information about the current
input source as follows. (Components connected to the
UNIVERSAL PORT jack are excluded.)
The following information can typically be displayed.
*1 If the input signal is analog, “Analog” is displayed. If the
input signal is PCM, the sampling frequency is displayed. If
the input signal is digital but not PCM, the signal format is
displayed. Information is displayed for about three seconds,
then the previously displayed information reappears.
When you connect an -capable Onkyo component, you
must configure the input display so that can work
properly.
This setting can be done only from the front panel.
The Music Optimizer function enhances the sound quality
of compressed music files.
You can temporarily mute the output of the AV receiver.
Displaying Source Information
1 Press RECEIVER followed by DISPLAY
repeatedly to cycle through the available
information.
Tip
• Alternatively, you can use the AV receiver’s DISPLAY.
Input source
Input signal
resolution
Output
resolution
Signal format *1
Listening mode
Sampling
frequency
Changing the Input Display
1 Press TV/CD, GAME or VCR/DVR.
“TV/CD”, “GAME” or “VCR/DVR” appears on the
display.
2 Press and hold down TV/CD, GAME or VCR/DVR
(about 3 seconds) to change the input display.
Repeat this step to select the desired input display.
■
TV/CD:
■
GAME:
■
VCR/DVR:
Note
• DOCK can be selected for the TV/CD, GAME or
VCR/DVR input selector, but not at the same time.
• Enter the appropriate remote control code before using the
remote controller for the first time (
➔
page 61).
Using the Music Optimizer
1 Press MUSIC OPTIMIZER on the front panel.
The Music Optimizer and M.Opt indicators light on
the display.
Tip
• Alternatively, you can use the remote controller’s HOME
and arrow buttons.
• See “Music Optimizer” for more details (
➔ page 55).
Muting the AV Receiver
1 Press RECEIVER followed by MUTING.
The output is muted and the MUTING indicator
flashes on the display.
Tip
• To unmute, press MUTING again or adjust the volume.
• Muting is automatically cancelled when the AV receiver is
set to standby.
TV/CD
→
DOCK
→
→
TAPE
GAME
↔ DOCK
VCR/DVR
↔ DOCK