Using the audio settings of quick setup, Music optimizer” f, En-40 – Onkyo TX-NR414 User Manual
Page 40
Advanced Operations
En-40
You can change various audio settings from the Quick
Setup (
).
Note
• These settings are not available in either of the following cases:
– The “Audio TV Out” setting is set to “On” (
).
– “HDMI Ctrl (RIHD)” is set to “On” (
) and you’re
listening through your TV speakers.
Tone Control
■
Bass
`
–10 dB to 0 dB to +10 dB in 2 dB steps
You can boost or cut low-frequency sounds output
from the front speakers.
■
Treble
`
–10 dB to 0 dB to +10 dB in 2 dB steps
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when Direct or Pure Audio (European, Australian
and Asian models) listening mode is selected.
Operating on the AV receiver
Speaker Levels
■
Subwoofer Level
`
–15 dB to 0 dB to +12 dB in 1 dB steps
■
Center Level
`
–12 dB to 0 dB to +12 dB in 1 dB steps
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to standby. To save the setting you made
here, go to “Level Cal (Level Calibration)” (
)
before setting the AV receiver to standby.
Note
• You cannot use these function while the AV receiver is muted.
• These settings cannot be used while a pair of headphones is
connected.
• Speakers that are set to “No” or “None” in “Sp Config (Speaker
) cannot be adjusted.
Late Night
■
Late Night
For Dolby Digital and Dolby Digital Plus sources, the
options are:
`
Off
`
Low:
Small reduction in dynamic range.
`
High:
Large reduction in dynamic range.
For Dolby TrueHD sources, the options are:
`
Auto:
The Late Night function is set to “On” or “Off”
automatically.
`
Off
`
On
Turn this setting on to reduce the dynamic range of Dolby
Digital material so that you can still hear quiet parts even
when listening at low volume levels—ideal for watching
movies late at night when you don’t want to disturb
anyone.
Note
• The effect of the Late Night function depends on the material that
you are playing and the intention of the original sound designer,
and with some material there will be little or no effect when you
select the different options.
• The Late Night function can be used only when the input source
is Dolby Digital, Dolby Digital Plus, or Dolby TrueHD.
• The Late Night function is set to “Off” when the AV receiver is
set to standby. For Dolby TrueHD sources, it will be set to
“Auto”.
Music Optimizer
■
Music Optimizer
`
Off
`
On
The Music Optimizer function enhances the sound quality
of compressed music files. When set to “On”, the M.Opt
indicator lights on the AV receiver’s display, and the
MUSIC OPTIMIZER indicator (North American and
Taiwanese models) lights on the front panel.
Tip
• (North American and Taiwanese models) Alternatively, you
can use the AV receiver’s MUSIC OPTIMIZER.
Note
• The Music Optimizer function only works with PCM digital
audio input signals with a sampling rate below 48 kHz and analog
audio input signals.
• The Music Optimizer is disabled when the Direct or Pure Audio
(European, Australian and Asian models) listening mode is
selected.
• The setting is stored individually for each input selector.
Using the Audio Settings of Quick
Setup
1
Press
TONE repeatedly to select either “Bass” or
“Treble”.
2
Use
– and + to adjust.