Onkyo DR-645 - Manual (Page 19)

19
En
Recording a Source
You can record a source onto a CD recorder or a cassette
tape recorder connected to the COAXIAL DIGITAL
AUDIO OUT jack or the LINE OUT jacks.
Dimmer
Muting
Super Bass boost
You can reinforce the bass sound to maintain rich, full
bass at low volume.
Adjusting the bass and treble
You can change the bass and treble sound between “-5” to
“+5”.
■
Stand-by power consumption
When charging the iPod, the power consumption may
reach up to a maximum of 14 W.
Note
• Do not unplug the USB flash drive before playback is stopped.
Basic Operation
1
Select a source to be recorded by pressing DVD,
iPod/USB, FM, or LINE.
2
Start recording.
• When the recording device is connected to the
LINE 1 IN jack and the LINE OUT jack, you
cannot select the LINE 1 Source for the recording
source.
Press DIMMER to dim the display.
Press DIMMER again to cancel the dimmer
function.
To mute the sound temporarily, press MUTING.
Press MUTING again to restore the sound.
• “MUTING” blinks on the display while muting is
engaged.
• If you change the volume when the sound is muted,
it will be unmuted.
Press S.BASS to get the effect.
Press S.BASS again to cancel the effect.
1
Press TONE repeatedly to select Bass or Treble.
2
Press VOL to adjust the sound level.
Listening to a Disc
1
Press DVD to select “DVD Source”.
• When no disc is loaded in the disc tray, “NO
DISC” is displayed.
2
Press on the unit to open the tray.
3
Place the disc on the disc tray (with the printed
side up).
4
Press on the unit again to close the tray.
• Some discs may automatically start playback.
5
Press / to start playback if playback has not
started automatically.
If a menu is shown on screen (some DVD or video
discs may show such a menu), see “On-screen
Menu”.
Listening to an iPod
1
Press iPod/USB once or twice to select “iPod”.
2
Push your iPod firmly onto the unit’s dock
connector.
Never insert the iPod into dock connector without
the Universal Dock Adapter.
3
Press / to start playback.
Listening to a USB Flash Drive
1
Press iPod/USB once or twice to select “USB
Source”.
2
Plug your USB flash drive into the USB port.
It takes a few seconds for the unit to load the USB
flash drive. Some files may automatically start
playback.
• You can reverse steps 1 and 2.
3
Press / to start playback if playback has not
started automatically.