Onkyo DR-645 - Manual (Page 32)

32
En
■
Disc does not play
■
Poor radio reception
■
Unable to select Progressive Scan
■
Audio or subtitle languages cannot be set
■
Cannot display some files in USB flash drive
■
USB flash drive not supported
■
Timer does not work
■
Clock/timer setting erased
■
No Sound or Video
■
Remote Control does not work
■ Others
Insert a readable disc and ensure that the label side faces up.
Check the disc type, color system and regional code. Check
for any scratches or smudges on the disc.
Press MENU to exit the system setup menu.
Disable the password for parental control or change the rating
level.
If condensation is suspected, unplug the AC power cord and
leave DR-645 for two to three hours in the room temperature
before playing any discs.
Increase the distance between the unit and your TV or VCR.
Fully extend the FM antenna.
Connect an outdoor FM antenna instead.
Make the component video connection.
The disc is not recorded with sound or subtitles in multiple
languages.
The audio or subtitle language setting is prohibited on the
disc.
The number of folders or files in the USB flash drive has
exceeded a certain limit. This phenomenon is not a
malfunction.
The formats of these files are not supported.
The USB flash drive is incompatible with the unit. Try
another one.
Set the clock correctly.
Switch on the timer.
Power has been interrupted or the power cord has been
disconnected.
Reset the clock/timer.
iPod
Make sure your iPod is connected properly.
If there’s no video, make sure your iPod supports TV out.
Make sure your iPod is playing.
On your TV, make sure that the video input to which the unit
is connected is selected.
Make sure all plugs are pushed in all the way.
Try resetting your iPod.
Video on the iPod LCD screen is not output to the monitor.
Only the video content is output.
The iPod video signal is not output via HDMI.
Make sure your iPod is seated properly on the dock
connector. If your iPod is in a case, it may not connect
properly, so always remove the case before inserting your
iPod into the DR-645.
Your iPod cannot be controlled while it’s displaying the
Apple logo.
If you’re using the remote control, be sure to point it toward
DR-645 when you want to control your iPod.
Try resetting your iPod.
Changing setting will not take effect if done while pausing or
video playback.
Depending on the backlight setting on your iPod, the display
may become dim during use. If the display is hard to see,
change the backlight setting on your iPod.
Connecting the iPod to the dock automatically turns on the
TV output.
If the iPod does not function normally even when inserted in
the dock connector, check that the iPod is firmly inserted. If
the iPod still does not function after checking, remove the
iPod from the dock, wait a few seconds, and insert it again.