Olympus VP--1 - Manual (Page 63)

E-63
Troubleshooting
Check the following matters before requesting servicing.
* Has the power plug become disconnected from the
outlet?
* Is the lamp cover properly attached?
* Has the internal temperature become high? When the
internal temperature becomes very high, to protect
the unit the power will not switch on.
* Has the lamp timer exceeded 1100 hours? The power
will no longer switch on once the timer has exceeded
1100 hours.
* Has the connected input been selected?
* Is the cable of the input connector properly connected?
* If there is connection to a personal computer, is a
signal being output from the personal computer?
* Has a signal that is higher than the supported fre-
quency of the projector been input?
* Check that the image adjustment brightness and con-
trast are not set to minimum.
* Has the lamp burned out?
* Is the STATUS indicator blinking?
* When a monochrome video signal cannot be dis-
played properly, set the input selection to "YCbCr".
* Is the projector installed properly?
* Is the keystone adjustment properly adjusted?
* Is the lens properly focussed?
* Are the projection screen and the projector installed
at the proper distance?
* Has the projection distance exceeded the focussing
range?
* Is there condensation on the lens and other parts?
When the projector has been stored in a cold location
and the power is switched on in a warm location, there
may be condensation on the lens and other internal
optical parts. Should this occur, wait several minutes
until the condensation disappears.
* Is the input signal being supported for resolution and
frequency? Check the resolution of your personal com-
puter.
* When the image is broken in the horizontal or vertical
direction, or the image does not fill the entire screen,
select a suitable aspect ratio.
* When a component signal is being input, the color
space setting is different. Perform the color space
setting.
No power
No video
Distorted video
Blurred video
Image position is shifted
and doesn’t display prop-
erly
Image is broken
Overall color of image is
strange
Problem
Check
Reference
Page
E-24
E-61, 68
E-61, 62
E-62
E-28
E-18 – 22
E-20
E-70
E-33, 46
E-61
E-61
E-28
E-26
E-34, 53
E-27
E-16, 17
E-16, 17
–
E-70
E-30, 51
E-50