Oce North America LIGHTJET 500XL - Manual (Page 16)

LightJet 500XL Maintenance Guide
×
see copyright, disclosure, use and duplication information on pg ii 48058-A 2-6
4. Power down the LightJet
®
500XL (use the procedures described in the LightJet
®
500XL
User Guide to ensure proper cool down of the blue laser) and disconnect the AC power cord
from the wall outlet.
5. Open the right side door to access the drum.
6. Using caution, extract the media from the drum. To facilitate the removal of media the
media guides should be in their parked position. The guides can be retracted by hand by
applying a force at their drive point. Be careful not to exert any appreciable force on the light
shield.
7. Close the right side door.
8. Connect the AC power to the wall outlet and power up the LightJet
®
500XL.
Advance Jam
To clear a media jam that has occurred while media is advancing through the machine:
1. Cut the media before the infeed pinch rollers by running a knife in the slot between the idler
roller and the first guide vane. Be careful not to cut the rubber coating on the idler roller
with the knife.
2. Using the control panel select Set Up/Motor Control/All Motors Forward. Attempt to
advance 10 inches of media.
3. If the media moves freely, use “All Motors Forward” again for 135 inches to wind the media
onto the outfeed roll. Inspect the media for damage. If media is torn, inspect the inside of
the imaging drum for debris. Clean drum if necessary.
4. If the media does not move freely it must be removed manually from the drum. Cut the
media at the cutter bar. Remove the infeed and outfeed media rolls.
5. Power down the LightJet
®
500XL (use the procedures described in the LightJet
®
500XL
User’s Manual to ensure proper cool down of the blue laser) and disconnect the AC power
cord from the wall outlet.
6. Open the right side door to access the drum.
7. Using caution, extract the media from the drum. To facilitate the removal of media the
media guides should be in their parked position. The guides can be retracted by hand by
applying a force at their drive point. Be careful not to exert any appreciable force on the light
shield.
8. Close the right side door, connect the AC power to the wall outlet and power up the
LightJet
®
500XL.
End of Section