Omega Speaker Systems FMG3000 - Manual (Page 3)

3
1
2
3
4
JP2
FREQUENCY OUT
DO NOT REMOVE
Connect output signals and power
to this 4-terminal block.
2.
4.
3.
3.
Sensor Type Pipe Size Jumper Position
½ in. to 2½ in.
FMG3001 DN15 to DN65
FMG3002 3 in. to 4 in.
DN80 to DN100
FMG3101 5 in. to 6 in.
FMG3102 DN125 to DN150
8 in.
DN200
FMG3201 10 in. to 12 in.
FMG3202 DN250 to DN300
1.
Omega FMG-3000 Series Magmeter
1. Quick Start Guide
This manual contains the general installation, wiring and calibration data for the Omega FMG-3000 Series Magmeter with Frequency or
Current output. The basic steps are outlined on this page. See each referenced section for detailed information.
1. Position the PIPE SIZE Jumper according
to your pipe size. See Sec. 5 Pg. 6.
2. Install the Magmeter into the pipe.
Use Omega installation fi ttings ONLY.
The installation fi tting is critical to
Magmeter performance.
See Sec. 3-4, Pg. 5.
3. Connect POWER and OUTPUT wiring.
FMG-3001 and FMG-3101 Frequency out:
See Sec. 8 Pg. 8.
FMG-3002 and FMG-3102 current out
wiring: See Sec. 7 Pg. 7.
GROUNDING
Without a good Earth Ground, the
Magmeter may not operate effi ciently. See
Sec. 6 Pg. 7.
4. Route the wiring out through the two cable
ports. Use appropriate hardware to secure
the FMG-3000 from moisture intrusion.
One Liquid Tight Connector is included.
See Sec. 5 Pg. 6.
HAND-TIGHTEN THE THREADED NUT ONTO THE
INSTALLATION FITTING. DO NOT USE TOOLS!
DO NOT USE THREAD SEALANT OR LUBRICANTS ON
THE FITTING THREADS OR THE SENSOR CAP.
Topic: Page
1. Quick Start Guide 1
2. Specifi cations 2
3. Installation: Pipe Fittings 3
4. Selecting a Location 3
5. Hardware Confi guration 4
6. General Installation and Grounding Tips 5
Topic: Page
7. Wiring the Magmeter with 4 to 20 mA Loop out 5
8. Wiring the Magmeter with Frequency Output
6
9. Calibration Data 7
10. Maintenance and Troubleshooting 11
11. Ordering Information 12