Oki BISM2 - Manual (Page 2)

www.ezurio.com
2. Features
Feature Implementation
Bluetooth Transmission Class 1
Fully Bluetooth pre-qualified Bluetooth 2.0
Range 250 metres typical (free space)
Frequency 2.400 – 2.485 GHz
Max Transmit Power +6dBm
Min Transmit Power -27dBm
Receive Sensitivity Better than -86dB
Data Transfer rate Up to 300Kbps
Serial Interface RS-232 bi-directional for commands and data using AT commands
Serial parameters
Default 9600,n,8,1 - Configurable from 1,200bps to 961,200 bps.
Support for DTR, DSR, DCD, RI, RTS, CTS
Physical size
22.8 x 33.8 x 7.6 mm, 8g
24.0 x 69.0 x 7.6mm, 9g (BISM1 Form Factor)
Current consumption
Typically 22mA during data transfer in standard power mode. Lower
powers are attainable with a configurable low power mode.
Low power sniff mode 2.5mA typ
Temperature Range Normal operation: -40°C to +85°C
Supply Voltage 3.6V – 7.0V
Brown-out Integrated brown out detection
Interface Levels 3.3V Logic
Audio
Audio can be transferred over SCO channels through the PCM interface
at 64kbps. PCM can be configured as master or slave.
Profiles FTP Server, SPP, DUN, FTP, Audio Gateway, Headset, Handsfree
Multipoint Max 7 slaves
Field upgradeable Over UART
Protocols
Single point firmware is controlled and configured using AT
Commands. Standard multipoint firmware uses a simple packet based
protocol and requires a host to enable the module to function
effectively.
Single point only allows a point to point connection whereas multipoint
allows more than one simultaneous connection.
GPIO
9 x digital
2 x analogue (8 bit resolution)
Indicators 1 x programmable LED (small form factor board only)
Lead free Lead-free and RoHS compliant