Oki BISM2 - Manual (Page 26)

www.ezurio.com
Insulator Material PA , beige natural
Stacking height 3.0 mm ; 3.5 mm ; 4.0 mm ; 5.0 mm
Insertion force 21.8N
Withdrawal force 1st 10N
Withdrawal force 50th 10N
Maximum connection cycles 50
12. Qualification
12.1 Bluetooth Qualification Process
The following safety precautions must be observed during all phases of the operation, usage, service
or repair of any application incorporating this Module. Manufacturers of the RF equipment are advised
to convey the following safety information to users and operating personnel and to incorporate these
guidelines into all manuals supplied with the product. Failure to comply with these precautions
violates safety standards of design, manufacture and intended use of the product. Ezurio assumes no
liability for customer failure to comply with these precautions.
12.2 Safety Information:
Switch off the Bluetooth device before boarding an aircraft. Make sure it cannot be switched on
inadvertently. The operation of wireless appliances in an aircraft is forbidden by many airlines to
prevent interference with communications systems. Applications that could result in use on aircraft
should carry appropriate warnings.
12.3 Qualifications
12.3.1 RF approvals
The Module is listed as a Bluetooth Product in terms of the Bluetooth SIG Program Reference
Document (PRD). This means that it can be integrated into end products without further testing or
approval listing. The manufacturer must state the Ezurio part number and product reference in his
literature in order to meet the requirements of the Bluetooth and regulatory approvals.
A list of the countries where the Module is approved will be provided by Ezurio as required. As a
minimum the product is listed in Europe, Scandinavia and USA. Ezurio assumes no liability for
customer failure to comply with national RF approvals.
12.3.1.1 EMC Emissions
EN 300 328 V1.5.1 (2004-08)
12.3.1.2 EMC Immunity
EN 301 489-1 V1.4.1 (2002-08)
12.3.1.3 FCC
FCC Part 15.247:2004 (Subpart C)
FCC ID: PI401B