Onkyo TX-SR303 - Manual (Page 33)

33
First Time Setup—Continued
6 Use the Down [ ] button to
select “Surround,” and then use
the Left and Right [
]/[ ] but-
tons to select Small, Large, or
None.
Small: Select if the surround speak-
ers are small.
Large: Select if the surround speak-
ers are large.
None: Select if no surround speakers
are connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
7 Press the [SETUP] button.
Setup closes.
TESTING THE SPEAKERS
To test that all of the speakers are working properly,
press the remote controller’s [TEST TONE] but-
ton. The test tone will be output by each speaker in
turn and the name of each speaker will appear on the
display. To turn off the test tone, press the [TEST
TONE] button again.
• If the test tone is not produced by a speaker, or it’s
produced by a speaker other than that shown on
the display, you may have wired the speakers
incorrectly and you should check your connec-
tions (see page 17).
• If the test tone is not produced by a speaker and its
name does not appear on the display, you may
have set the speaker settings incorrectly (see
page 32).