Opticon 25-WEDGE-04 - Manual (Page 8)

Page 4
User Maintenance
There is no user maintenance required for the
OPTICON smart wand. Replacement wand tips
and cables are available from Opticon. To remove
wand tip, simply rotate the tip counter-clockwise.
To remove cable, simply pry the rubber cover
backward and remove the cable from the wand.
Programming the Smart Wand
This User’s Guide provides an easy way of chang-
ing certain parameters. A parameter is changed
by scanning a specific bar code associated to a
specific function.
To select menu options:
1. Scan START. The smart wand will beep
intermittently to indicate that it is ready to be
programmed.
2. Make parameter selection from menu. A beep
and a read light (MSH-220 only) indicates that
the parameter has been scanned.
3. Scan END. This completes the operation and
the new parameter is saved in memory.
The smart wand is typically programmed as a
keyboard wedge for IBM’s AT or PS/2 models 50,
60, 70 and 80. If the host computer is not one of
these models, please refer to “Computer Type
Selection” on page 18 of the bar code scanning
menu to make another selection.
NOTE: (
B
) A pointing finger indicates scanner
default settings.