Oregon Scientific FSP-301 - Manual (Page 9)

9
EN
CHANGE SETTINGS
Press and hold CLOCK or ALARM for 2 seconds to
enter setting mode. Then, press UP or DOWN
to change each setting. Press and hold to enter fast-
setting mode. Press CLOCK or ALARM to switch
between settings.
REMOTE UNIT SET UP
Up to 3 remote units can be used with this product to
monitor outdoor temperature. The measurement unit
(˚C or ˚F) and channel number (1, 2, or 3) switches
are located in the battery compartment, and should
be set prior to installation.
NOTE Additional remote units sold separately. If you
are using more than one remote unit, be sure to select
a different channel number for each unit.
INSTALLATION
Mount the remote unit on a flat surface using the
recess hole on the back of the unit.
For best results:
· Before you insert the batteries, select the
measurement unit and channel number first.
· Place the unit out of direct sunlight and moisture.