Oki 1220n User Manual
Page 190
ES 1220n Troubleshooting • 190
Printer takes a long time to start printing.
Toner rubs off when you rub the printed surface.
Possible cause
Remedy
The printer has to warm
up returning from power
save mode.
In the printer menu settings, set power save to a
higher value to increase the length of time before
entering power save mode (
SYS CONFIG MENU
→
POW SAVE TIME
).
The image drum carries
out a cleaning process
to ensure print quality,
which takes time.
Wait until this process has been completed.
The fuser unit adjusts
temperature, which
takes time.
Wait until this process has been completed.
The printer is
processing data from
another interface.
Wait until this data is processed.
Possible cause
Remedy
Media Weight and
Media Type settings
may not be appropriate.
Set the value of media weight in the menu to
the next heaviest one (
MEDIA MENU
→
YYY
MEDIA WEIGHT
).
Packing materials were
left on the fuser when it
was installed.
Careful! Fuser my be HOT!
Open the top cover and check to be sure that
all the packing materials were removed from
the fuser. To remove the fuser see “Fuser
Replacement” on page 147.