Oricom TP68 - Manual (Page 7)

- Setting up -
7
3 Setting up
3.1 General Information
NOTE! Before setting up, it is essential that you read the General Information
at the beginning of this operating manual.
3.2 Check contents of pack
The following items are supplied:
one telephone
one telephone line cord
one user guide one handset
one curly cord one desk stand
one power supply four batteries Type AAA 1.5V
3.3 Connecting the handset
After unpacking your telephone, you must first connect the telephone handset to
the base unit. First take the short end of the curly cord and plug it into the
socket on the handset. Turn the telephone base over and plug the long end into
the socket marked with a handset
symbol located on the right hand side.
Feed the cable through the cable channel.
3.4 Insert batteries
Fit the batteries (supplied) before connecting your telephone to the telephone
network. The battery is required for the display, handsfree and other functions
of the telephone.
1. Make sure that the telephone is not connected to the telephone network.
2. Locate the battery compartment on the underside of your telephone.
3. Open the battery compartment with a pen tip or a pointed object.
4. Insert the batteries, ensuring that the polarity is correct.
5. Close the battery compartment.
The battery must be changed when the display shows .
Do not use rechargeable batteries, as these could possibly lead to a short
circuit. When replacing the battery use only AAA 1.5V alkaline batteries. Do not
throw batteries into fire or immerse in water. Do not dispose of old or faulty
batteries with the normal household waste.