Onkyo RFR-5 - Manual (Page 6)

6
Mounting
The RF Receiver can be mounted to a piece of
furniture using the included mounting plate and
the 4 screws. Take into account the range and the
working angle of the IR blaster as explained on p.
4. Also make sure to place the RF Receiver in a
central position aimed directly at your devices.
Note:
It is adviced not to place the RF Receiver inside a
metal closet as RF signals can be disturbed by
metal objects.
Installation
1 Remove the mounting plate from the
bottom of the RF Receiver.
2 Screw the plate to a rack, closet or
another piece of furniture.
Provide sufficient space to connect the power
adapter and to slide the RF Receiver back on.
Note:
Depending on the surface, it may be possible
to attach the RF Receiver to the furniture
using a piece of 2-sided tape. Look for the
right position and make sure there is
sufficient space.
3 Slide the RF Receiver on the
mounting plate.
Using the IR Emitters
Like the IR blaster of the RF Receiver, the IR
emitters send out IR signals. You can use the IR
emitters as an alternative for the IR blaster.
Note:
It is adviced not to place the RF Receiver inside a
metal closet as RF signals can be disturbed by
metal objects.
When to use the emitters
The IR emitters can control devices the IR blaster
cannot reach, for instance when there is limited
space around the receiving eyes of the devices,
e.g. in a small closet.
Note:
The IR emitters can also be used in
combination with the IR blaster of the RF
Receiver. Both send out IR signals
simultaneously. This allows you to operate
several devices using both the IR blaster and
the IR emitters.