Onkyo RFR-5 - Manual (Page 7)

7
Installation
Connecting the Power Adapter
When connecting the power adapter it is
recommended that you plug the adapter into the
RF Receiver before you plug it into the socket.
When connected you will see a red LED on the
RF Receiver.
Note:
To avoid interference, the adapter cable should
not be placed directly above or below the RF
Receiver.
How to use the emitters
The IR emitters can be attached to the
surrounding surface facing the receiving eyes or
directly to the receiving eyes.
1 Attach the emitters to a surface
above, below or in front of the
receiving eyes of your devices (for
aesthetic appearance or when it is
difficult to locate the receiving eye).
–OR–
Attach the emitters directly to the
receiving eyes of your devices.
2 Plug the IR emitters into the RF
Receiver.
To avoid interference, the wires of the
emitters should be kept away from the RF
Receiver as far as possible.
Connecting Onkyo components
equipped with IR IN terminal
The 3.5mm mono cable (included with the RF
Receiver) can be used to connect the RF Receiver
to Onkyo components equipped with IR IN
terminal for controlling the Onkyo components.