Onkyo RFR-5 - Manual (Page 8)

8
Installation
Settings
As the RF Receiver “communicates” with the
Chad Remote Controller, you have to set the same
Receiver ID (identity) on both appliances. The
settings depend on whether you have a single RF
Receiver or multiple RF Receiver.
Single RF Receiver
When you use only one RF Receiver, you can
accept the default setting for the Receiver ID
(ID=0). Make sure your Chad Remote Controller
is set to the same default setting (see the Chad
User Guide for more details).
Multiple RF Receiver
If you want to operate several of your devices
independently, e.g. grouped on different
locations, you will need multiple RF Receiver.
When using several RF Receiver, it is important
to assign a unique Extender ID to each RF
Receiver. 16 Extender IDs (from 0 to 9 and from
A to F) can be assigned.
1 Choose an Receiver ID for the RF
Receiver by turning the ID dial with a
small screwdriver.
3 Try to operate your devices with the
Chad Remote Controller.
The red LED will blink when the RF Receiver
receives a correct command.
4 Repeat this procedure for every RF
Receiver.
RF Interference
If your devices are not responding to commands
or if the red LED on the IR blaster is blinking
without sending commands, it might be possible
that there is RF interference. This can be the case
when other RF appliances are operated nearby,
for instance by your neighbours.
When you notice RF interference, you have to
choose another channel on your RF Receiver. 4
channels (CH from 0 to 3) can be assigned.
1 Choose a channel for the RF Receiver
by turning the CH dial with a small
screwdriver.
2 On the remote controller, choose the
same channel for each device
controlled by the RF Receiver.
Refer to the Chad manual for more information.
3 Try to operate your devices with the
remote controller.
2 On the Chad Remote Controller,
choose the same Extender ID for each
device controlled by the RF Receiver.
Refer to the Chad User Guide for more
information.