Oricom eco50 - Manual (Page 8)

6 BASIC OpERATION
During standby
Note:
If the power is not connected to the base unit.
The cordless handset
CANNOT operate.
Cordless handset's LCD display
HANDSET 1 : Handset number
: Current battery level
: A constant signal icon indicates the
cordless handset is linked to the base unit.
When signal icon is flashing the handset
needs to be re-registered.
Note:
The signal icon will also flash if the handset is out of range.
Answering an incoming call
When there is an incoming call, the phone rings and flashes
on the display. If a CID record is received, flashes and the
caller information is displayed.
1. Press [
] key to answer the call.
2. Press [ ] key again to end the call.
Making an external call
Normal dialling
1. Press [ ] key.
2. Enter a telephone number. If you enter more than 12
digits, you only see the last 12 digits on the display.
3. Press [ ] key to end the call.
Pre-dialling
1. Enter a telephone number.
2. When necessary, press [ ] to erase the digit individually.
3. Press [
] key to dial.
4. Press [ ] key to end the call.